3d print glock frame

3d Print Glock Frame - In April 2020, a Glock-type self-loading pistol was seized by the Toronto Police Service. To the non-expert, it might look like a modified factory-made Glock pistol, but it's actually a gun that's been made using a 3D-printed frame. The frame is built using 3D, although the frame is built using 3D, it is known as 'part kit conversion' (PKC) construction. A printing factory or printing house. PKC designs are generally favored where commercial parts are readily available, but complete firearms—or major components such as frames or receivers—are legally regulated.

A PKC Glock-type cell-loading pistol with a 3D-printed frame seized by the Toronto Police Service in April 2020 (Source: Toronto Police Service)

3d Print Glock Frame

The frame used in this particular PKC build appears to be the 'BTB G26' model It's a 3D-printable frame that accepts a Glock 26 slide and barrel, uses a Glock 19 locking block, and includes Glock 19-style internal rails. The two screws shown at the top left of the picture hold rails (probably made of aluminum) that guide the slides against each other. Other visible parts such as the slide and trigger are not factory-original Glock parts Instead, they are made by an aftermarket manufacturer at a lower cost than genuine Glock parts Some of these parts are marketed specifically for use in PKC builds that do not involve 3D printing at an 80% discount.

Fosscad: 3d Printed Abs P80 Glock 26 (wookie 26)

The fold lines commonly seen on 3D-printed Glock frames are hard to spot in this area, but a trained eye will notice them around the ejection lever. The frame is attached to the story layer below; They indicate that the frame is printed from top to bottom of the printer The frame appears to be hand stitched

ARES' latest report on 3D-printed pistol frame manufacturing and the nature of PKC. Discussion in Desktop Arms: Essential Small Arms Industrial Production Technologies

Remember that all weapons and ammunition are dangerous Since all weapons are loaded unless you prove otherwise yourself Treat all bullets as if they were alive Unless you have special knowledge Firearms or ammunition are not considered safe until they have been inspected by a subject matter expert. Unless you're specifically trained to do this, you should be close enough to move the controls, not to move them or change them to shoot. If you encounter an unexploded ordnance (UXO) or explosive remnant (ERW), always remember the 'ARMS' literal:

Picture frame 3d print, glock metal frame, 3d print glasses frame, photo frame 3d print, 3d frame, drone frame 3d print, glock 3d, frame print, quadcopter frame 3d print, 3d print, 3d print sunglasses frame, glock 30 frame